- 3 -
CONNECTOR PIN NUMBERS AND WIRE COLOR CODES
10-PIN HARNESS
# WIRE COLOR FUNCTION NOTES
1) White Parking See the wiring diagram for the proper connection of
Light (+) this wire. For negative output see Page 5.
2) Red +12 VDC Main Power. Connect this wire to the POSITIVE
terminal of the vehicle’s battery, with the supplied
fuse installed at the
BATTERY END of this wire.
3) Brown Siren (+) Connect this wire to the RED wire of the Siren.
Output is +12 volts when the alarm is triggered.
4) Black Ground Connect this wire to a clean, solid GROUND.
Do Not
confuse this wire with the short, black antenna wire.
Do Not Ground The Antenna Wire!
5) Orange Starter Negative output to the Starter Interrupt relay.
Interrupt (–) See Wiring diagram for connections.
6) Gray Channel 2 Negative pulse output when Button #2 of transmitter is
pressed for 3 seconds. See the diagram on Page 5.
7) Green (–) Door Connect this wire to door pinswitches that are
Trigger NEGATIVE when the door is open.
8) Blue (–) Trigger Negative trip input for connection to an external
sensor or door/trunk /hood pin switch.
9) Violet (+) Door Connect this wire to door pinswitches that are
Trigger POSITIVE when the door is open.
10) Yellow Ignition Connect to a source of TRUE IGNITION, a wire that is
hot in both the RUN and START positions.
2-PIN VALET/OVERRIDE PLUG-IN CONNECTORS:
# PLUG COLOR FUNCTION
1) Blue Valet Override Plug-in the Blue 2- pin connector for the VALET switch
Switch to the Blue receptacle on the circuit board.
2-PIN LED PLUG-IN CONNECTORS:
# PLUG COLOR FUNCTION
1) Red LED Plug-in this connector for the LED
to the Red receptacle on the circuit board.
3-PIN DOOR LOCK PLUG-IN CONNECTOR:
# WIRE COLORS FUNCTION
1) Green Door Negative output pulse to door LOCK circuit. See
Lock (–) door lock wiring diagrams on Page 5 for connections.
2) Red (+) Optional 12 V Output.
3) Blue Door Negative output pulse to door UNLOCK circuit.
Unlock (–) See door lock wiring diagrams on Page 5 for connections.
4-PIN DUAL ZONE SHOCK SENSOR PLUG-IN CONNECTOR:
# FUNCTION
1) – Dual Stage Plug-in the Dual two-stage shock sensor’s connector
Shock Sensor to the 4-pin receptacle on the circuit board.
3-PIN ACCESSORIES PLUG-IN CONNECTOR:
# WIRE COLORS FUNCTION
1) Green/Black (-) Dome light Connect to optional relay for Dome light (See page 5).
2) Red Horn Connect to (-) wire from the horn. May require relay
(See page 5).
3) Yellow (-) 3rd. Channel Connect to Remote Starter input.
(12 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce