Black Widow Security BW X-Z Series Instalační manuál stáhnout pdf (Strana 6)

PROBABLE SUGGESTED

SYMPTOM CAUSE CORRECTION

Alarm will not go RED or YELLOW wire not connected RED wire should connect directly to

into Code Learning to the correct power source. Code the battery. Connect YELLOW wire to

Mode Learning sequence done to slow. true ignition wire (Not at Fuse Block).

Redo Code Learning sequence faster.

Unit is triggered any BW296P sensor not adjusted correctly, Readjust BW-296P sensor.

time it is armed. BLUE or GREEN wire shorted Disconnect the BLUE or GREEN

to ground. wire to see if symptom stops if so

check wires for short.

Alarm will not rearm VIOLET wire is connected to pos- Check VIOLET and GREEN

or will not passively itive voltage, GREEN wire is wires with doors closed and

arm. connected to ground,YELLOW wire open, and YELLOW wire with

is connected to permanent positive ignition switch off and on, for

voltage, or pinswitch is bad. correct voltage changes. Repair

and/or rewire as needed.

Alarm will arm from Dipswitch #4 is off. Set dipswitch #4 to ON.

transmitter but will

not passively arm.

Remote Control does Defective Remote Control. Bad Replace Remote Control or its

not arm or disarm battery. Antenna wire is battery. Un-ground antenna.

alarm. grounded.

Valet does not work. Bad switch or wrong activation Repair or replace switch or check

sequence when using the transmitter user instructions for proper

activation sequence

Flashing output does Bad connection on WHITE Check WHITE wire. Connect

not work. wire or the drive polarity is a SPDT Relay to this wire and

wrong for the circuit being apply the opposite polarity to the

driven. circuit being driven.

Door locks do not Defective GREEN or BLUE Check GREEN and BLUE wires

lock/unlock correctly, wire from door lock connector plug, on door lock connector plug.

or action is reversed. GREEN and BLUE wires on door lock Check vehicle’s door lock

connector plug reversed, or wrong system for method of operation.

door lock wiring diagram used. Reverse wiring to door relays.

1 2 3 4 5 6 7

Žádné komentáře

Black Widow Security BW X-Z Series Instalační manuál Strana 6