Black Widow Security BW X-Z Series Instalační manuál Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
8
© 2000, DAVID LEVY COMPANY, INC.
(1060) February 2000, Rev. 1
TROUBLESHOOTING
SYMPTOM
Range is poor
Antenna wire is grounded, mod-
ule is picking up interference
from vehicles electrical system
Make sure antenna is not con-
nected to anything, relocate mod-
ule away from vehicle computer
modules
Vehicle starts when
armed
Wrong starter wire was cut Locate proper starter wire
and reconnect
Car will not start when
system is disarmed
Bad connection on gray wire in
harness
Repair connection at starter
wire, replace module
Alarm system inter-
mittently works
Bad power and ground
connections
Replace and secure power and
ground connectors
Car wont start;Alarm
wont function properly
Vehicle battery dead or drops
below 7.5 volts when trying to
start the vehicle
Replace battery or charge
Alarm doesnt Arm or
Disarm
Ignition input has voltage on it,
make sure the power wire
shows 12V+
Turn key off - wrong wire con-
nected to green wire main
harness
Alarm will not go into
Code Learning Mode
Not leaving ignition in the on
position after turning it on &
off five times. Not turning igni-
tion on/off rapidly enough
(5 sec.)
Repeat procedure quicker
Alarm will not go into
Code Learning Mode
Green wire not connected Connect green wire to an ignition
source
Alarm chirps 4 times 30
seconds after system is
Armed
Factory Dome light Delay is
longer than 30 seconds. Door
open or defective pin switch
If dome light delay is longer than
30 seconds no correction neces-
sary. Replace defective pin switch
Parking lights do not
flash
Wrong wire connected to the
Yellow wire, or requires a neg-
ative output
Correct the wire connected to
the Yellow wire, using a SPDT
relay reverse polarity on Yellow
wire (see diagram)
PROBABLE CAUSE
SUGGESTED CORRECTION
DLC/U.S.A.
12753 Moore Street
Cerritos, California 90703
Zobrazit stránku 7
1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře