Black Widow Security BW RAS 651 Uživatelský manuál stáhnout pdf (Strana 10)

10

crank time setting has been increased by

one step.

6. Release the valet switch to exit.

7. Test remote starter and if necessary

repeat steps 1-6.

Gas and Diesel Modes

The default engine type setting is Gasoline.

For diesel vehicles, the engine type must be set

to one of the three Diesel options. If a glow

plug wire is not available, the unit has a built-in

timer that waits 15 seconds before cranking the

starter. For vehicle’s with a glow plug light

(wait-to-start indicator) the BLUE wire should

be connected to verify the glow plugs are warm

before the engine begins cranking.

ADDING TRANSMITTERS

To add a new transmitter to the system have

the desired transmitters ready and follow the

Code Learning sequence.

To enter Code Learning Mode:

1. Within 3 seconds, turn the ignition on, off,

on,off and leave on.

2. Press and hold the Valet switch.

• The parking lights will turn on.

• The horn will honk once (optional).

3. Continue to hold the Valet switch.

• The parking lights will turn off.

• The horn will honk 5 times (optional).

4. Release the Valet switch.

5. Press Button 1 on the transmitter.

• The parking lights will flash and horn will

honk (optional).

6. Repeat step 5 for each additional

transmitter, up to four total transmitters.

7. Turn off the ignition.

NOTE:If a transmitter is lost or stolen,make sure

to code all 4 transmitter memory locations.

(Example: If only one transmitter is used,repeat

step 3 three more times to remove any

previously programmed transmitters.)

RELAY WIRING DIAGRAMS

TRUNK RELEASE DIAGRAM

ANTI-GRIND RELAY

BW651 final.qxd 10/18/2005 10:58 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře