Black Widow Security BW 3 Channel Instalační manuál stáhnout pdf (Strana 7)

PROBABLE SUGGESTED

SYMPTOM CAUSE CORRECTION

Alarm will not go RED or YELLOW wire not connected Connect RED wire directly to a

into Code Learning to the correct power source. Ignition constant +12V. Connect YELLOW wire

Mode sequence performed to slow. to true ignition wire (not at fuse

block).Repeat ignition sequence faster.

Unit is triggered any Shock sensor not adjusted Readjust Shock sensor.

time it is armed. correctly, Door/hood inputs connected Disconnect the Door/hood input

to wrong polarity. wires to see if symptom stops.

If so check wires for wrong polarity.

Alarm will not rearm Door (GREEN or VIOLET) inputs Connect door input wires to correct

or will not passively connected to wrong polarity. Door pin- polarity. Connect ignition input to

arm. switches defective. true ignition.

Alarm will arm from Dipswitch #4 is off. Set dipswitch #4 to ON.

transmitter but will

not passively arm.

Transmitter does Defective Transmitter. Bad battery. Replace Transmitter or its

not arm or disarm Antenna wire is grounded. battery. Un-ground antenna.

alarm. Replace module.

Valet does not work. Bad switch or wrong activation Repair or replace switch or check

sequence. user instructions for proper

activation sequence

Flashing output does Bad connection on WHITE wire Check WHITE wire.

or the drive polarity is wrong Connect a SPDT Relay to this wire

for the circuit being driven. if negative polarity is needed.

Door locks do not Defective GREEN or BLUE Check GREEN and BLUE wires

lock/unlock correctly, wire from door lock connector plug, on door lock connector plug.

or action is reversed. GREEN and BLUE wires on door lock Check vehicle’s door lock

connector plug reversed, or wrong system for method of operation.

door lock wiring diagram used. Reverse wiring to door relays.

(See page 5 for door lock wiring)

1 2 3 4 5 6 7 8

Žádné komentáře

Black Widow Security BW 3 Channel Instalační manuál Strana 7