Black Widow Security BW FM 250 Instalační manuál stáhnout pdf (Strana 5)

INSTALLATION

INSTRUCTIONS:

1. Mount the module and

program dip switch functions:

Look for a suitable mounting location

under the dash or inside the vehicle that

will be difficult for a potential thief to

locate the module, but allow for a con-

venient installation position.

2. Mount the extended range

receiver/pager module:

This module is connected with an 8 foot

coaxial to the main module. Carefully

route the cable up the driver side pillar

post and mount the Receiver/pager mod-

ule up in the upper left corner of wind-

shield or behind the center rear view

mirror. Antenna can be mounted in any

direction.Adhere the module to the glass

with the supplied 2 sided tape.

3. Mount the Siren:

Locate a suitable place under the hood,

away from hot and moving engine parts

such as manifolds, turbo chargers, fan

belts, etc. Secure siren by screwing brack-

et to a solid location under the hood.

Make sure that there is no outside access

to both siren and wire from underneath

the vehicle or through the grill.

Point the siren down so that water may

not accumulate inside the siren bell.

Ground the black wire of the siren to a

solid ground; preferably, use a star washer

and ring terminal.

Using either tape or split loom tubing,

cover and route the red wire to the

firewall and run inside the vehicle to the

module location.

Always use either existing grommets or if

a new hole is needed to be drilled always

protect the wire from chaffing by

installing a proper size grommet.

4. Mount the shock sensor:

Mount the dual stage shock sensor using

a wire tie to the steering column, or thick

wire harness, or even a dash brace under

the dash close to the module.

Plug the harness into the shock sensor,

then plug the other end into the 4 pin

white connector on the module. Make

sure that the adjustment screw is accessi-

ble for later testing and adjustment. Do

Not mount sensor under the hood!

5. Install the Status

Indicator (LED):

Locate a suitable place for the status indi-

cator (LED), drill the appropriate size

hole (7/16”). Make sure there is enough

clearance for the LED to fit all the way in,

and can be easily seen from outside the

vehicle. Carefully push the connector

through the hole and route the wire and

5

1 2 3 4 5 6 7 8 9 10 ... 15 16

Komentáře k této Příručce

Žádné komentáře