Black Widow Security BW RAS 130 Instalační manuál Strana 4

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 3
4
3-Pin Red Connector: Plug-in connector port
for optional features harness.
GREEN/BLACK WIRE - 3rd channel output (-).
Connect to a relay for optional trunk release etc.
RED WIRE - Factory Disarm output (-).
Connect to the wire that requires a ground
pulse to disarm the factory alarm system. The
RED wire provides a ground pulse when the
remote transmitter is used to unlock the doors
or start the vehicle.
YELLOW WIRE - Vacuum Switch input. For
diesel vehicles, or vehicles where a tach wire or
spark plug wire is not available, the YELLOW
wire may be connected to an optional vacuum
switch. Connect the other side of the vacuum
switch to ground.
2-Pin Red Connector: Plug-in connector port
for LED. Mount LED in an area where it may be
easily seen from either side of the vehicle.
2-Pin Blue Connector: Plug-in connector port
for program/service switch. Mount program
switch in an area that is easily accessible from the
drivers position.
2-Pin White Connector: Plug-in connector port
for horn honk/dome light harness.
WHITE/YELLOW - horn output (-)
RED/BLACK - Dome light output (-)
5-Pin Antenna Connector: Plug-in connector
port for extended range receiver. Plug harness
into 5-pin connector, route cable up pillar post,
place double sided tape on flat side of receiver
module and place in corner of windshield.
Remote Programmable Features:
Step Function Button 1 (On) Button 2 (Off)
1. Arming Mode Passive Active
2. Passive Lock On Off
3. Auto Re-arm On Off
4. Normal/Silent Arming Normal Silent
5. Door Unlock Pulse Single Double
6. Door Lock Pulse Length .75 Seconds 3 Seconds
7. Ignition Lock On Off
8. Auto Cold Start Defeat Disable Cold Start Enable Cold Start
9. Cold Start Timing Every 2 Hours Every 1 Hour
10. Trunk Disarm Feature Disable Enable
11. Passive Arm Warning Chirps Delete On Off
12. Open Zone Chirp Timing 10 Seconds 60 Seconds
13. Remote Start Run Time 15 Minutes 25 Minutes
14. Lock Before & After Engine Crank On Off
15. Lock After Engine Shutdown On Off
16. Parking Light Operation Normal Car Locator Feature
Zobrazit stránku 3
1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře