4
❑ Install your throttle servos and connect the throttle linkages, using the
pushrod wires and adjustable connectors provided. If you're using
two-stroke engines, you will need to adjust the location of the throttle
pushrod wire accordingly.
☞
Install the adjustable connectors 1/2" (13mm) out from the center of the
servo arms to prevent the pushrods from interfering with the fuel tanks.
Make sure that you install and connect both throttle
linkages exactly the same way, so that both throttles will be synced
as closely as possible during ight.
Apply a drop of thin C/A to the nut on each adjustable
connector to keep them from coming loose during ight.
❑ Install one engine mount assembly and one engine onto each fuselage
boom, using the socket-cap screws, machine screws, washers and nuts
provided. A four-stroke engine is shown. Installing a two-stroke engine
will be the same.
Each engine's drive washer should be 4-1/2"
(114mm) out from the rewall to line up correctly with the
cowlings. Note that the engines should be mounted on their
sides, toward the right side of the fuselage booms, too.
STEP 2: INSTALLING THE AILERON AND FLAP CONTROL LINKAGE ASSEMBLIES
❑ Install one aileron servo into each wing panel. Each servo output
shaft should be toward the leading edge. You will need to install a 12"
long servo extension lead to each servo and run it through the wing.
❑ Install the control linkages, using two threaded pushrod wires, two
control horns, two clevises and four wood screws provided. Each
control horn should be positioned approximately 4-1/4" (108mm) out from
the inboard edge of the aileron.
You may need to trim the servo mounting rails and/or the servo cutout in the outer wing panel to t your servos.
❑ Install one ap servo into each wing panel. Each servo output shaft
should be toward the trailing edge.
❑ Install the control linkages, using two threaded pushrod wires, two
control horns, two clevises and four wood screws provided. See the
important note below about positioning the ap control horns.
STEP 3: INSTALLING THE ENGINES
The engine mounting beams are adjustable to t the width of different sized engines. Make sure when you
adjust the width of the mounting beams to t your engines that you keep the mounting beams centered on the rewall.
STEP 4: INSTALLING THE THROTTLE CONTROL LINKAGE ASSEMBLIES
The control horn on the left wing panel should be positioned approximately 6" (152mm) out from the inboard edge of
the ap and the servo arm should point toward the wing tip. The control horn on the right wing panel should be positioned approximately
4-3/8" (111mm) out from the inboard edge of the ap and the servo arm should point toward the root end. Having both servo arms
point in the same direction will allow you to use a standard Y-Harness and still make both servos move the same direction.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce