Black Widow Security BW 2800 Specifikace stáhnout pdf (Strana 7)

❑ Install a remote fueling valve into each cowling to make it easy to fuel

the airplane, then install the cowlings to the fuselage booms, using the

six large wood screws provided.

❑ Install your propellers and each spinner, using

the two sheet metal screws provided.

❑ Locate and drill 5/32" diameter holes through each cowling for the mounting screws.

STEP 10: INSTALLING THE NOSE GEAR

❑ Install the nose gear onto the nose gear mounting rails in the center

fuselage pod, using the four large wood screws provided. The front edge

of the nose gear mounting base should be pushed up against the forward

bulkhead.

❑ Install the wheel, using the wheel collar and machine screw provided.

 This step details the installation of the included xed nose gear. If you will be installing retractable landing

gear, please skip ahead to page 13.

STEP 11: INSTALLING THE STEERING CONTROL LINKAGE ASSEMBLY

❑ Fit and glue the plywood servo tray into the slot in the forward and

center bulkheads.

❑ Cut the length of pull-pull cable in half and secure one end of each

cable to each of the steering couplers, using two of the crimp collets

provided.

 Apply a drop of

thin C/A to the crimp collets for

an extra measure of security.

❑ Install your steering servo into the servo tray. Notice the position of

the servo output shaft. It should be toward the back of the fuselage.

❑ Connect the pull-pull cables to the servo arm, using the two threaded

couplers, two crimp collets and two clevises provided.

 Make sure that the pull-pull cables are adjusted tautly,

but not so tight that they put strain on the servo or nose gear.

 The steering servo cutout should be toward the front of the fuselage.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Žádné komentáře

Black Widow Security BW 2800 Specifikace Strana 7