Black Widow Security BW 2800 Specifikace Strana 6

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 5
6
Install your rudder servos into the servo trays. Notice the position of
the servo output shafts. They should be toward the back of the fuselage.
Make a Z-Bend in the pushrod wires and connect them to the servo arms.
Glue the front of the pushrod guide tubes to the bottom of the wing
mounting support bulkheads.
STEP 8: INSTALLING THE MAIN LANDING GEAR
Install one plywood mounting plate onto the landing gear mounting
rails in each fuselage boom, using the eight large wood screws provided.
The front edge of each mounting plate should be 3/4" (19mm) behind the
front bulkhead.
 There is one right and one left mounting plate. Make
sure that you install each mounting plate so that the predrilled hole in
the landing gear mounting slot is toward the inner mounting rail.

This step details the installation of the included xed main landing gear. If you will be installing retractable
landing gear, please skip ahead to page 13.
Drill a 13/64" diameter hole through the landing gear mounting rail,
using the predrilled hole in each landing gear mounting slot as a guide.
Insert the landing gear wires into the mounting slots and secure them
into place, using the four landing gear mounting straps and eight small
wood screws provided.
 The coil in each landing gear wire should be toward
the back of the fuselage booms.
Install the wheels, using the two wheel collars and two machine
screws provided.
STEP 9: INSTALLING THE COWLINGS
Install three cowl mounting brackets onto each fuselage boom, using
the six smaller wood screws provided. Make sure that the brackets are
ush with the fuselage boom sides and that the U-Shaped side is toward
the outside.
 Position one bracket at the 12
O'Clock position, one bracket at the 8 O'Clock position
and one bracket at the 4 O'Clock position.
Test-t and cut out each cowling for your engines and mufers. When aligned properly, the back edge of each cowling should overlap
the rewall 1-1/4" (32mm). For our four-stroke engine installation, we routed the mufers out the bottom center of each cowling.
Zobrazit stránku 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Komentáře k této Příručce

Žádné komentáře